How to make an FM antenna can be learned by anyone with a good interest in technology. It is actually quite easy to build your own FM modulator. Building your own radio is not as hard as it sounds. You need to be able to read, understand and follow simple directions that are provided on the FM modulator home site.

 

Before starting your project, you will need a few items. First, you will need a scanner to receive the analog signal. If your scanner does not have this, you will need an FM modulator. Antenna wiring should also be part of your list. Just get the right wire and get started.

 

Second, you will need a VCR or DVD to record your signals. You can find a VCR in the local electronics store. It is important to make sure that your signal strength is strong enough to receive it from any direction. You may need an AM/FM receiver, but you can choose a different antenna wire to connect than the one used to make the antenna. The final item needed is a VCR or DVD. Record the incoming signals and store them on your VCR.

 

The next step is to get a FM modulator. This is a FM radio tuner that you can attach to your existing antenna. It is usually located in the back of the vehicle, behind the dash board. When turned on, it will send out the proper signals needed for your FM receiver. When you tuned your car’s radio correctly with a conventional antenna, you would need to have a dipole for the front of your car and a coil in each ear for the back.

 

To start, you will need two VCRs or DVDs. You will need to record three hours of radio programming. You will need to play the recorded program from the stereo to each VCR or DVD. Turn on the VCR or DVD that contains the audio recording. On the other VCR or DVD, select the play icon and begin playing. Wait until the movie begins to run and then switch to the television to watch it.

 

In order to receive an FM signal, you must have a speaker and a stereo connected to the VCR or DVD for the best results. You will also need to have a scanner available. You will place this scanner at least 10 feet away from the vehicle and facing toward the back of the vehicle on the passenger side so that you will be able to receive the audio from the rear speakers.

 

You should be listening to your AM/FM radio stations when you receive these signals. Play the music through each ear and adjust the volume to find the level that you like. If needed, you can use the volume controls to do this. Then repeat this process with each ear, but only if necessary. This is the best way to tune each ear separately.

 

To tune the antenna correctly, you need to know how to listen and compensate properly. For instance, if you are listening with one ear and adjusting the volume, do not increase it suddenly because you may disturb the sound. Instead, lower the volume slowly until you can clearly hear the faintest signals. Finally, be patient because it takes a few seconds for each satellite radio station to send and receive signals. These tips on how to make an am fm antenna will help you get the strongest signals and therefore enjoy more enjoyable radio entertainment.

 

Once you have adjusted the satellite radio antenna appropriately, you must focus on getting a strong signal. You can do this by focusing your antenna on the directional antenna. For those with multiple antennas, try putting the directional antenna towards the stronger signal first and then towards the weaker ones.

 

To receive strong signals, you need to have an amplifier, which is available in different wattage. The wattage will determine the power of the signal that you will be able to receive. In order to tune the antenna properly, you should consider the strength of the signals. If you are receiving weak signals or if your antenna has a weak signal, consider changing your amplifier wattage.

 

Now that you know how to make an am Fm antenna, you should know where to find strong signals. The best place to start is by using the stronger antenna. Keep in mind that strong signals usually travel a long way from their source. If you are receiving signals from a distant location, you should try to adjust your antenna as much as possible. If you do not have strong signals from your location, try to move closer to the satellite.